How do I configure my HA setup to use link aggregation? You can optionally set other interface settings. If port 2 and port 3 are available, the following CLI commands create an aggregate called "link_agg" with an IP/netmask of 172.168.1.2/255.255.255.0 on the root vdom using those two interfaces. How do I configure an interface to use link aggregation using CLI commands? it is a FGT-5000 backplane interface, it must be visible.it is not referenced in any firewall policy, VIP, IP Pool or multicast policy.it does not have any VLAN subinterfaces.it has no DHCP server or relay configured on it.it has no defined IP address and is not configured for DHCP or PPPoE.it is in the same VDOM as the aggregated interface.it is not already part of an aggregated interface.it is a physical interface, not a VLAN interface.The FortiGate v3.0 Administration Guide chapter on creating interfaces lists the restrictions for creating a trunk. Some of it is included below.Īn interface is available for aggregation only if How can I tell what interfaces can be used in a trunk? FortiGate models supporting Link Aggregation are described in the related article FortiGate 802.3ad Link Aggregation FAQ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |